Welcome to the website of Shandong Gangyan Grinding Ball Co.,ltd. !

Phone:+8615163800896 | E-mail:

First-Piece Diameter Recheck After a Grinding Ball Size Change

A change of rolling tooling, production diameter or setup is a natural inspection hold point. The nominal size printed on a production order is not evidence that the first ball actually meets the agreed dimensional requirement. A first-piece check connects the setting change to a measured result before routine production resumes.

Forged grinding balls in assorted diameters; illustrative product image, not a first-piece measurement record
Forged grinding balls in assorted diameters; illustrative product image, not a first-piece measurement record

Why the first piece matters

A change of rolling tooling, production diameter or setup is a natural inspection hold point. The nominal size printed on a production order is not evidence that the first ball actually meets the agreed dimensional requirement. A first-piece check connects the setting change to a measured result before routine production resumes.

A practical five-step release procedure

  1. Identify the order, material grade, nominal diameter, tooling or roll setting, shift and operator. Record the change and segregate any material produced before approval.
  2. Select a representative first piece after the process has stabilized. Follow the agreed sampling and measurement method rather than treating a single measurement as proof of the whole batch.
  3. Measure with a suitable calibrated instrument at the agreed positions and orientations. Record individual readings, not only an average; account for roundness where the acceptance specification requires it.
  4. Compare readings with the actual contract drawing or agreed tolerance. Do not substitute a universal tolerance: limits depend on the order, size, applicable standard and measurement method.
  5. Have the responsible quality person release the setup, retain the measurement record and identify the start of the accepted batch. Continue in-process and final sampling under the agreed inspection plan.

What to record

Record the order and lot reference, equipment adjustment, nominal diameter, measurement instrument and calibration status, individual readings, applicable tolerance, inspection date, inspector, decision and corrective action where needed.

Record / ID Nominal Ø Measured Ø Agreed limit Disposition
________ ________ ________ ________ ________

How to handle an out-of-tolerance result

If the first piece is outside the agreed limit, hold affected production, correct the setup, remeasure a new first piece and document the disposition of material made since the last accepted check. A measurement video can support traceability but does not replace a signed inspection record or calibrated readings.

Questions buyers ask

Is nominal 100 mm the measured diameter? No. Nominal size is the order designation; measured diameter is the observed value.

Does a passing first piece guarantee the entire lot? No. Routine process monitoring and lot inspection remain necessary.

Can buyers request evidence? Yes. Agree on a first-piece record, sampling plan, photos or video and batch identifiers before production.

For a quotation or an inspection plan, send the required ball diameters and tonnage for each diameter, together with the applicable dimensional standard or agreed tolerance.

Forged grinding ball products · Shandong Gangyan